Month: October 2019

Gas/Hot Water System Repair Tips

When you are in trouble with your water heater, go around the house and check for hot water at all of the fixtures and faucets. Perform the following diagnostics:

1. Be confirmed that the gas to the water heater has been turned on. You should turn the gas control knob to PILOT to save the burner from igniting when you are looking inside. Eliminate the metal cover at the bottom of the water heater and aim to see if the heater and/or pilot light– the little flame at the end of the pilot gas supply tube– is lit.

2. If the water heater’s pilot light has gone out, It’s also possible that the gas inlet valve has been closed partially or all the way. If so, turn the handle parallel to the line and relight the pilot. If the pilot won’t light, the thermocouple may be defective—either call your gas utility company or a water heater repair person. 

3. If the burner is not on, replace the cover and also make sure the thermostat is set to around 120 degrees F. If it isn’t, change it, turn on a warm water faucet, and then wait a few minutes to see if the hot water heater burner ignites. If it doesn’t spark, leave the hot water running and attempt decreasing and then increasing the temperature level setting on the dial until the burner stirs up.

4. If the heater stirs up, change the cover and also turn the thermostat back to a suitable setting. If the heater does not fire up, have the water heater looked into by an appliance fixing person. It could be that the heater’s thermostat is faulty. Replacement is best left to a home appliance repair person or a hot water heater expert.

5. If you smell a garlic-like scent, turn the gas valve control to OFF. Wait until the gas scent has dissipated prior to relighting the pilot light. If the gas odor is solid as well as doesn’t dissipate, instantly shut off the gas supply shut off, ventilate the room, as well as call a plumbing technician or your gas energy firm from a remote location.

If your water comes out of the faucet with a brown, yellow, or red tint to it, there could be corrosion occurring inside your water heater tank or in the pipes in your home. If your water comes out smelling like rotten eggs, there could be bacteria in the hot water heater tank. You might need to replace the anode rod in the tank.

Tips on Washing Machine Repair

A washing machine helps us an efficient way to clean loads of laundry including clothing and home textiles. The machine might need to repair at any time for whatever reason. If your washing machine does not work properly, then you have to look deeply at it. We provide the best maintenance tips for your washing machine. Keep reading:

Need to inspect the hoses

You should check your washing machine’s water hoses for signs of wear or weakness a few times monthly year. If you find any cracks or blistering, replace the hose. Most manufacturers recommend replacing the hoses every five years.

Prevent flood damage

On the occasion that your washing machine’s fill hoses ruptured or water degree button malfunctions, you’ll have immediate water damage in the room. Washing Machine Overflow Frying pan For smaller leaks and drips, this prominent plastic pan fits underneath a washing machine and will shield the floor from water damages because of overflow and leakage. It has a fitting to accommodate drain line attachment.

Don’t overload it

We should always follow the owner’s manual’s instructions for appropriate loading sizes. Actually, oversized loads will throw the machine off balance.

Keep it level

If your washing machine is not exactly level, with all four legs on the floor, it may rock to and fro and vibrate highly. It’s best to keep the machine as near the flooring as feasible. The closer the machine sits to the flooring, the less it will certainly vibrate. The front legs are flexible with a locknut. Position the legs at the wanted elevation and also tighten the lock nut versus the body of the machine to ensure that the legs can not rotate. Some models additionally have flexible legs in the back, as well. 

An appropriate amount of detergent

Regardless of what’s recommended on detergent packaging, follow your owner’s handbook for the maker’s advised amount of detergent and that could be helpful for you.

Clean the inside regularly

It prevails for the detergent residue to develop inside of washing machine tubs. Make use of a cleaner once monthly to maintain high-efficiency washing devices devoid of odor-causing residue.

Clean out the fabric softener dispenser

Use a damp rag and hot water to clean the dispenser periodically.

Polish the outside

Splashed detergent, tarnish cleaner as well as fabric softener completely dry to a sticky mess. This all-purpose cleaner and a dust cloth will certainly make cleaning easy.